Reconnect Data Cables and Power Cords
- Reconnect the data cables to the rear of the server, as required.
If the cable management arm (CMA) is in the way, extend the server
approximately 13 cm (5 inches) out of the front of the rack.
- Reconnect the power cables to the power supplies and secure them with the
Velcro straps as shown in the following figure.
- If necessary, reinstall the cables into the CMA and secure them with Velcro
straps or cable straps, depending on which version of the CMA you are
- If you pulled the server out of the rack to make it easier
to connect the cables, push the server into the rack until the slide-rail
locks (on the front of the server) engage the slide-rail assemblies.
You will hear an audible click when the server is in the
normal rack position.