JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Oracle Switch ES1-24

Service Manual

search filter icon
search icon

Document Information

Using This Documentation

Product Notes

Related Documentation

CLI Command Modes


Support and Accessibility

Detecting and Managing Faults

Front Panel LEDs

Rear Panel LEDs

Check Switch Status (LEDs)

Sensors Overview

Check Switch Status (Oracle ILOM)

Component Sensor Targets

Motherboard Sensor Targets

Preparing for Service

ESD Precautions

Tools Needed for Service

Replaceable Components

Remove the Front Support and Air Duct

Remove the CMA

Install the CMA

Servicing Power Supplies

Power Off a Power Supply

Remove a Power Supply

Install a Power Supply

Power On a Power Supply

Servicing the Fan Module

Remove the Fan Module

Install the Fan Module



Install a Power Supply

  1. Power off and remove the power supply to be replaced.


  2. Verify that the slot where you are installing the power supply is clean and free of debris.
  3. Orient the power supply with the status LEDs on the left and the release tab on the right.
  4. Slide the power supply into the open slot, pushing at the handle.
    image:Figure shows the power supply being installed.
  5. When the power supply seats, push firmly so that the release tab clicks to secure the power supply into the switch.
    image:Figure shows the power supply being secured.
  6. Power on the power supply.

    See Power On a Power Supply.

Related Information