JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Oracle Switch ES1-24

Service Manual

search filter icon
search icon

Document Information

Using This Documentation

Product Notes

Related Documentation

CLI Command Modes


Support and Accessibility

Detecting and Managing Faults

Front Panel LEDs

Rear Panel LEDs

Check Switch Status (LEDs)

Sensors Overview

Check Switch Status (Oracle ILOM)

Component Sensor Targets

Motherboard Sensor Targets

Preparing for Service

ESD Precautions

Tools Needed for Service

Replaceable Components

Remove the Front Support and Air Duct

Remove the CMA

Install the CMA

Servicing Power Supplies

Power Off a Power Supply

Remove a Power Supply

Install a Power Supply

Power On a Power Supply

Servicing the Fan Module

Remove the Fan Module

Install the Fan Module



Remove the CMA

Note - If you are removing the CMA from a switch with the data cables in the cold aisle, the procedure is the same, however the following illustrations differ slightly from your situation.

  1. Loosen the green captive thumbscrews and remove the cover from the CMA.
    image:Figure shows removing the CMA cover.
  2. Set the cover aside.
  3. Using a No. 2 Phillips screwdriver, remove the two M6x14 screws securing the CMA.
    image:Figure shows removing the CMA.
  4. Lower the CMA out from under the cables, and set it aside.
  5. Consider your next step.
Related Information