JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Oracle Switch ES1-24

Service Manual

search filter icon
search icon

Document Information

Using This Documentation

Product Notes

Related Documentation

CLI Command Modes


Support and Accessibility

Detecting and Managing Faults

Front Panel LEDs

Rear Panel LEDs

Check Switch Status (LEDs)

Sensors Overview

Check Switch Status (Oracle ILOM)

Component Sensor Targets

Motherboard Sensor Targets

Preparing for Service

ESD Precautions

Tools Needed for Service

Replaceable Components

Remove the Front Support and Air Duct

Remove the CMA

Install the CMA

Servicing Power Supplies

Power Off a Power Supply

Remove a Power Supply

Install a Power Supply

Power On a Power Supply

Servicing the Fan Module

Remove the Fan Module

Install the Fan Module



Sensors Overview

The switch uses several configurable sensors and indicators to monitor switch power, voltage, and temperature.

The switch includes a sensor for each replaceable component. These sensors generate entries in the SEL when sensor thresholds are exceeded. Many of these readings are used to adjust the fan speeds and perform other actions, such as illuminating LEDs and powering off the switch.

You can also configure these sensors to generate IPMI PET and SNMP traps, as described in the Sun Integrated Lights Out Manager (ILOM) CLI Procedures Guide.


Caution - Do not use any interface other than the Oracle ILOM CLI or web interface to alter the state or configuration of any sensor or LED. Doing so could void your warranty.

You can view the system monitoring sensors and indicator parameters from the Oracle ILOM CLI or web interface.

Related Information