Caution - Do not connect the power cords to the storage server until the you have made the SP and host networking connections. The storage server includes a service processor (SP) that is used to configure and boot the host system. Connecting the SP and host networking cables first enables you to properly configure the host system and view SP messages. |
When power is connected, the storage server boots into standby power mode:
The SP OK/Fault LED flashes while the SP is starting, and the main Power/OK LED remains off until the SP is ready.
After a few minutes, the main Power/OK LED slowly flashes the standby blink pattern (0.1 seconds on, 2.9 seconds off), indicating that the SP (and Oracle ILOM) is ready for use. In standby power mode, the storage server is not initialized or fully powered on at this point.
For the location of the status indicator LEDs, see Front Panel Status Indicators, Connectors, and Drives and Back Panel Status Indicators, Connectors, Drives, and PCIe Slots.
Caution - Do not operate the storage server unless all fans, component heatsinks, air baffles, and the top cover are installed. Damage to storage server components can occur if the storage server is operated without adequate cooling mechanisms. |