This section describes the additional steps you need to complete to set up DAF deployment for environments where you want to increase performance by using multiple servers to perform the deployment.
Note: Unless you use ATG Content Administration, you cannot deploy different data from multiple Oracle Commerce Platform servers clusters to a single target. The multiple server setup described here applies only for situations where multiple servers are used as a single cluster to deploy the same data. For information about configuring deployment from multiple server clusters, see the Content Administration Programming Guide.
Set up a server lock manager and a client lock manager for the Oracle Commerce Platform server cluster (as for any other multi-server Oracle Commerce Platform configuration). For information, refer to the Platform Installation and Configuration Guide.
On each instance in the Oracle Commerce Platform server cluster, set the
/atg/dynamo/service/ServerName.propertiesfile to haveserverNameanddrpPortproperties that are unique for each instance in the cluster. For example, server A might be set as follows:serverName=serverA:8850
drpPort=8850Server B might be set with distinct values, as follows:
serverName=serverB:18850
drpPort=18850
Caution: Do not run the DAF.Deployment module on any server that is used as a standalone lock manager. Doing so causes the lock manager to attempt to deploy items, and the deployment deadlocks as a result.
