How to Connect the Terminal Concentrator
- Connect a DB-25 to RJ-45 serial cable (part
number 530-2152-01 or 530-2151-01) from serial port A on the administrative
console to serial port 1 on the terminal concentrator, as shown in Connecting the Administrative Console.
This
cable connection from the administrative console enables you to configure
the terminal concentrator. You can remove this connection after you set up
the terminal concentrator.
Figure 5 Connecting the Administrative
Console
- Connect the cluster nodes to the terminal concentrator
by using serial cables.
The cable connections from the concentrator to the nodes enable you to access the
ok prompt or OpenBoot™ PROM (OBP) mode on a
SPARC based system or a boot subsystem on an x86 based system by using the
pconsole utility. For more information, see Chapter 4, Booting a System in Booting and Shutting Down Oracle Solaris 11.3 Systems.
- Connect the public network Ethernet cable
to the appropriate connector on the terminal concentrator.
Note - The terminal concentrator requires a 10 Mbyte/second Ethernet
connection.
- Close the terminal concentrator bracket, and install
screws in holes 8 and 29 on the left-side rear rail of the cabinet (see Terminal Concentrator Bracket Installed on the Hinge).
Next Steps
Go to Configuring the Terminal Concentrator.