Install a PrizmMT Cable

1. Remove any filler plug (if installed) from the PrizmMT receptacle where you are installing the cable and visually inspect the receptacle.

   The receptacle should be clean and free of dirt or debris. If the receptacle is dirty, clean it.

   See Clean The PrizmMT Receptacle or Connector Ferrule.

2. Remove the protective cap from the cable connector and visually inspect the connector.

   The connector should be clean and free of dirt or debris. If the connector is dirty, clean it.

   See Clean The PrizmMT Receptacle or Connector Ferrule.

3. Align the PrizmMT connector to where it will connect.
4. Firmly press the PrizmMT connector into the receptacle until you feel a detent.
5. Continue installing the adapter.

   See Install the Adapter.

Related Information

• ESD Precautions

• Order Additional Hardware

• Cable Cautions

• Install the Adapter

• Standard MT and PrizmMT MPO Cables

• Clean The PrizmMT Receptacle or Connector Ferrule

• Verify the Adapter Installation (Oracle Solaris)

• Verify the Adapter Installation (Oracle Linux)

• Remove the Adapter

• Remove a PrizmMT Cable