See Install the Adapter.
Refer to the documentation for the server.
Refer to the documentation for your network hardware for more information at http://www.oracle.com/us/products/networking/overview/index.html.
If the green LED is not on, check the cable connections at the adapter and the IB switch.
# cfgadm -als "cols=ap_id:condition" hca Ap_Id Condition hca:10E07A83740004 ok
If more than one device is installed in the server, a row is displayed for each. Look for the row displaying hca:GUID where GUID is the 64-bit number from the physical label on the adapter. See Rear Panel.
The Condition column must display ok to indicate that the driver has discovered the hardware and is bound to it. Refer to the cfgadm_ib(1m) man page for details about the IB-specific extensions.
# cfgadm -als "cols=ap_id:info" hca Ap_Id Information hca:10E07A83740004 VID: 0x108e, PID: 0x2088, #ports: 0x2, port1 GUID: 0x10E07A83740005, port2 GUID: 0x10E07A83740006
If more than one IB HCA device is installed in the server, a row is displayed for each device. Look for the row displaying hca:GUID, where GUID is the 64-bit number from the physical label on the adapter. See Rear Panel.
Use the port number and GUID displayed by this command for your IB HCA device in the following step.
# dladm show-ib LINK HCAGUID PORTGUID PORT STATE GWNAME GWPORT PKEYS net7 10E07A83740004 10E07A83740005 1 up -- -- 8002,8005,FFFF net8 10E07A83740004 10E07A83740006 2 up -- -- 8002,8005,FFFF
The command displays the AP_ID column, where each row has the format of ib:Port GUID,P_Key, ipib. Match the Port GUIDs from the command in Step 7b with these port GUIDs. There must be one row corresponding to the port and P_Key setup by the Subnet Manager. If an entry is missing, check the Subnet Manager configuration.
# dladm show-part LINK PKEY OVER STATE FLAGS ibd0 FFFF net7 up ---- ibd1 FFFF net8 up ----