The program description deals with the following:
The data for configuration of printer, type Epson 300, can be updated, i.e. programmed, changed or cleared, with this program. Data which has already been stored can also be displayed for information.
Enter the number under which this printer is to be stored in the system. The interface and link to a processing unit should also be defined and the device-specific operation mode set.
The printer can be used for receipt print or as a remote printer.
Click on
the graphic for further help with programming of Remote printers.
The following description deals with all available options for update of this basic data.
As with nearly all other programs the following also applies here:
Field with firmly defined selection options
Select one of the options offered by clicking onto the field and with a second click choosing the operation mode required.
The system offers the following options:
Field with firmly defined selection options
Select one of the debug levels offered by clicking onto this field and with a second click confirming the selection.
The system offers the following debug levels:
Note:
Only select a value higher than "0" for
the debug level if a protocol for communications is required for error
analysis. Details can be found in file "errlog" in directory work
of the appropriate system unit.
Default = 10
Enter the number of lines the receipt is to advance after the last line has been printed and before it is cut off.
Default 32
Enter the number of characters to be printed on each line.
Field with firmly defined selection options
Select one of the baud rates offered by clicking onto this field and with a second click confirming the selection.
The system offers the following baud rates:
Field with firmly defined selection options
Select one of the parity settings offered by clicking onto this field and with a second click confirming the selection.
The system offers the following parity settings:
Field with firmly defined selection options
Select one of the code page settings offered by clicking onto this field and with a second click choosing the code page required.
Default 255
Enter a value in this field, to determine the code page index.
Default 100
Enter a value in milliseconds to define how long the release magnet of the connected drawer is to remain active.
Default 20000
Enter a value in milliseconds to define the intervals at which the status of the printer is to be called up. The appropriate message is sent if the response is negative.
Default 2000
Enter a value in milliseconds to define the intervals at which the status of the printer is to be called up. Printer offline is sent if the response is negative.
Field with firmly defined selection options
Select one of the options offered by clicking onto this field and with a second click choosing the operation mode required.
The system offers the following:
Entry range permitted: numeric 0 - 9
Enter a drawer no. in this field if one drawer is to be connected to this printer and if drawer opening from operator and payment type has been parametered. If two drawers are connected to this printer, the second drawer is given the value +1. This value must agree with the entry in Operator and in the appropriate Parameters of the payment type.
Entry range permitted: numeric 0 - 1
Enter 0 in this field if normal logo print is required or 1 if inverted logo print is preferred.
Path and name of BMP file for logo print
A logo can be printed on the receipt instead of the receipt heading text. If logo print is required, the name of the BMP file and the path in relation to the current work directory (e.g. work directory = work.10, BMP file in directory xpm; entry = ../xpm/BMP file name)
Please note the following:
A BMP file is created with the relevant program (e.g. "PAINT" for Windows). A colour depth of 1 bit (=2 colours) should be selected.
The size and ratio of the X/Y solution in Pixel is dependent on the printer on which the logo is to be printed.
The following values apply: