Push the LED indicator module and cable through the LED housing on the
server front panel [1].
Install the LED indicator module cable by carefully pulling the cable
through the cable trough along the left side of the chassis.
Note -
To ease installation of the LED indicator module cable, slightly
lift the SAS cable bundles from the cable trough along the left side
of the chassis.
Note -
Cable part number 7315469 is required for the LED indicator module.
Insert and tighten the two No. 2 Phillips screws to secure the LED
indicator module to the server front panel [1].
Install the FIM cable and Temp Sensor Access cover to the chassis by
inserting it into the FIM cable and Temp Sensor Access cover slot
[2].
Caution -
Be careful not to damage the temperature sensor when installing
the FIM cable and Temp Sensor Access cover to the chassis.
Install the three No. 2 Phillips screws to secure the FIM cable and
Temp Sensor Access cover to the chassis [2].
Reconnect the LED indicator module cable to the motherboard.
Note -
You might need to disconnect the SAS cable connections from the Oracle
Storage 12 Gb SAS PCIe RAID HBA, Internal card in PCIe slot 11 to access the
LED indicator module motherboard cable connection. See Servicing SAS Cables (FRU).