Documentation, Support, and Training
Understanding Switch Specifications
Understanding InfiniBand Cabling
Verify Shipping Carton Contents
Install the Switch in the Rack
Verifying the InfiniBand Fabric
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Controlling the Subnet Manager
Understanding Oracle ILOM on the Switch
Understanding Oracle ILOM Targets
Installing the Oracle ILOM Firmware
Acquire the Oracle ILOM Firmware Version 1.1.3
Install the Oracle ILOM Firmware Version 1.1.3
Administering Oracle ILOM (CLI)
Accessing Oracle ILOM From the CLI
Switching Between the Oracle ILOM Shell and the Linux Shell
Monitoring Oracle ILOM Targets (CLI)
Controlling Oracle ILOM Targets (CLI)
Upgrading the Switch Firmware Through Oracle ILOM (CLI)
Administering Oracle ILOM (Web)
Access Oracle ILOM From the Web Interface
Monitoring Oracle ILOM Targets (Web)
Controlling Oracle ILOM Targets (Web)
Upgrading the Switch Firmware Through Oracle ILOM (Web)
Accessing the Rear Panel Diagram
Accessing Status Pane Information
Monitoring Parameters and Status
Administering Oracle ILOM (SNMP)
Monitoring Oracle ILOM Targets (SNMP)
Controlling Oracle ILOM Targets (SNMP)
Display the Sensors' State (IPMI)
Display the Sensor Information (IPMI)
Display the System Event Log (IPMI)
Display FRU ID Information (IPMI)
Display Switch Status LED States (IPMI)
Disable the Locator LED (IPMI)
Understanding Oracle ILOM Commands
Understanding Hardware Commands
Linux Shells for Hardware Commands
Understanding InfiniBand Commands
Linux Shells for InfiniBand Commands
Understanding the SUN-DCS-MIB MIB OIDs
Understanding the SUN-ILOM-CONTROL-MIB MIB OIDs
Understanding the SUN-PLATFORM-MIB MIB OIDs
Displays power supply FRU ID information.
showpsufru slot
where slot is the power supply slot (0 or 1).
This hardware command displays FRU ID information for the power supplies.
The showpsufru command is available from the /SYS/Switch_Diag and /SYS/Fabric_Mgmt Linux shell targets of the Oracle ILOM CLI interface.
The following example shows how to display the FRU ID information for power supply 0 with the showpsufru command.
# showpsufru 0 Sun_SpecPartNo : 885-1165-02 UNIX_Timestamp32 : Wed May 6 09:18:21 2009 Sun_Part_Number : 3002143 Sun_Serial_No : BF0CG5 Vendor_ID_Code : 02a2 Initial_HW_Dash_Level : 02 PSU_Voltage 1 : 0x04b0 (1200) PSU_Current 1 : 0x186a (6250) PSU_Voltage 2 : 0x014a (330) PSU_Current 2 : 0x012c (300) Sun_Hazard_Class_Code : Y IPMI_Board_Manufacturer : EMERSON IPMI_Board_Product_Name : A237 IPMI_Board_Serial_Number: 1357ZHO-0919BF0CG5 IPMI_Board_Part_Number : 300-2143-02 #