Documentation, Support, and Training
Understanding Switch Specifications
Understanding InfiniBand Cabling
Verify Shipping Carton Contents
Install the Switch in the Rack
Verifying the InfiniBand Fabric
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Controlling the Subnet Manager
Understanding Oracle ILOM on the Switch
Understanding Oracle ILOM Targets
Installing the Oracle ILOM Firmware
Acquire the Oracle ILOM Firmware Version 1.1.3
Install the Oracle ILOM Firmware Version 1.1.3
Administering Oracle ILOM (CLI)
Accessing Oracle ILOM From the CLI
Switching Between the Oracle ILOM Shell and the Linux Shell
Monitoring Oracle ILOM Targets (CLI)
Controlling Oracle ILOM Targets (CLI)
Upgrading the Switch Firmware Through Oracle ILOM (CLI)
Administering Oracle ILOM (Web)
Access Oracle ILOM From the Web Interface
Monitoring Oracle ILOM Targets (Web)
Controlling Oracle ILOM Targets (Web)
Upgrading the Switch Firmware Through Oracle ILOM (Web)
Accessing the Rear Panel Diagram
Accessing Status Pane Information
Monitoring Parameters and Status
Administering Oracle ILOM (SNMP)
Monitoring Oracle ILOM Targets (SNMP)
Controlling Oracle ILOM Targets (SNMP)
Display the Sensors' State (IPMI)
Display the Sensor Information (IPMI)
Display the System Event Log (IPMI)
Display FRU ID Information (IPMI)
Display Switch Status LED States (IPMI)
Disable the Locator LED (IPMI)
Understanding Oracle ILOM Commands
Understanding Hardware Commands
Linux Shells for Hardware Commands
Understanding InfiniBand Commands
Linux Shells for InfiniBand Commands
Understanding the SUN-DCS-MIB MIB OIDs
Understanding the SUN-ILOM-CONTROL-MIB MIB OIDs
Understanding the SUN-PLATFORM-MIB MIB OIDs
Queries basic status of InfiniBand devices.
ibstat [-d][-e][-h][-l][-s][-p][-V] ca_name [ca_port]
where:
ca_name is the channel adapter name.
ca_port is the channel adapter port.
This InfiniBand software command displays basic information retrieved from the local InfiniBand driver. Output of the command includes:
LID
SMLID
port logical state
link width
port physical state
The ibstat command is similar to the ibstatus command, however, the ibstat command is a binary executable, has options to display channel adapters and ports, and provides more information than the ibstatus command.
The ibstat command is available from the /SYS/Switch_Diag and /SYS/Fabric_Mgmt Linux shell targets of the Oracle ILOM CLI interface.
The following table describes the options to the ibstat command and their purposes:
|
The following example shows how to display the basic status from the local InfiniBand driver with the ibstat command.
# ibstat Switch ’is4_0’ Switch type: MT48436 Number of ports: 0 Firmware version: 7.3.0 Hardware version: a0 Node GUID: 0x00212856cfe2c0a0 System image GUID: 0x00212856cfe2c0a3 Port 0: State: Active Physical state: LinkUp Rate: 40 Base lid: 16 LMC: 0 SM lid: 16 Capability mask: 0x4250084a Port GUID: 0x00212856cfe2c0a0 #
ibstat man page