About This Documentation (PDF and HTML)
SAS Device Access to the Chassis SAS-2 Domain
Host Access to Storage Module Resources Using the Sun Blade Zone Manager
How to Assign Storage to Hosts Using the CMM ILOM Web Interface
How to Assign Storage to Hosts Using the CMM ILOM CLI
Overview of Storage Module Management
Management Options Using the CMM ILOM
Management Options Using the Sun Storage 6Gb SAS REM RAID HBA (SGX-SAS6-R-REM-Z)
Management Options Using the Sun Storage 6Gb SAS REM HBA (SGX-SAS6-REM-Z)
Performing Maintenance and Hot Plug Actions
Preparing for Hot Plug Actions
Recovering Zoning Configurations
Upgrading Storage Module Firmware
Importing Existing Virtual Drives to a Replacement REM
Replacing a REM on a SPARC System
Replacing a REM on an x86 System
Storage Module Sensors and Indicators
Displaying Sensor and Indicator Information Using the CMM ILOM Web Interface
Displaying Sensor and Indicator Information Using the CMM ILOM CLI
Viewing the CMM ILOM Event Log
Missing SAS-2 Components Error
Server Module Not SAS-2 Capable Error
When CMM ILOM starts, it can take several minutes for all the ILOM services to come online. The amount of time it take depends on how many devices are installed in the chassis. If you attempt to perform zone management actions before the all ILOM services are online, you will see a “not ready” error message.
What to look for:
If you attempt to use the Sun Blade Zone Manager before the services are online, what you see depends on whether you are using the web interface or the CLI.
Note - The “not ready” message could appear whether zoning is enabled or disabled.
|
Actions to perform:
If you encounter this issue, wait an additional five minutes and then try again. You need to close and reopen, or refresh the page if you are in the CMM ILOM web interface.