Skip Navigation Links | |
Exit Print View | |
Sun Dual 10 GbE PCIe 2.0 Fibre Channel Over Ethernet Software User's Guide |
Understanding the FCoE Software
Installation Overview (Windows)
Enabling the FCoE Software (Linux)
Enable FCoE During the Linux Installation
Enable FCoE After a Linux Installation
Resolve SAN-Boot Errors (RHEL6.0/OL6.0)
Remove the FCoE Software Package (Linux)
Installing the FCoE Software (Windows)
Upgrade Guidelines for Software Release 15.4 (Windows)
Validation and Storage Certification
Download and Install the Driver (Windows)
Boot Over a 10GbE Network (Linux)
Set Up the FCoE Boot Option ROM (Windows)
Configure the Cisco Nexus 5000 Series Switch
Configure the Brocade 8000 Series Switch
Configuring Driver Parameters (Linux)
Driver Parameter Settings (Linux)
The following instructions use eth3 as the FCoE interface. The interface name in your network environment is likely to be different.
# ifconfig eth3 up
# ethtool eth3 Settings for eth3: Speed: 10000Mb/s Link detected: yes
If you do not see the link detected, check the cabling and correct any issues before you proceed.