Understanding the Installation
Understanding Management and Power Cabling
Management Connection Overview
Single-Switch Location Guidelines
Attach the Rails to the Switch
Attach Telco Adapters to the Rack Slides
Attach the Rack Slides to the Rack
Install the Switch Into the Rack
Install the Air Duct and Front Support
Attach Data and Management Cables
Prepare the Front Support and Small Air Duct
Verify the DHCP-Assigned IP Address and Host Name
Configure Network Management From the CLI (SER MGT)
Log Into the Oracle ILOM Web (NET MGT)
Log Into the Oracle ILOM CLI (NET MGT)
Log Into the Oracle ILOM CLI (SER MGT)
Change a SEFOS User Privilege Level
Configure Network Management From the Web Interface
Configure Network Management From the CLI
Log Out of the Oracle ILOM CLI
Configuring the SEFOS Environment
Configuring the Switching Feature
Configuring the Routing Feature
Check Switch Status (Oracle ILOM)
Modulation in the host ports uses frequencies of up to 500 MHz to achieve 10Gbps transmission over copper twisted-pair cabling. This modulation requires suppression of both external and internal noise up to 500 MHz.
The 10GBASE-T ports on the switch support the following types of twisted-pair copper cables:
Category 7, shielded (100m)
Category 6A, shielded and unshielded (100m)
Category 6, shielded and unshielded (55m)
Category 5e, shielded and unshielded (55m)