Remove and Install the CMOD Cover
When removing or installing the CMOD cover, always maintain component
serviceability requirements with regard to static protection. To protect
components from damage, always use an anti static mat and wrist strap.
Before You Begin
-
To remove the CMOD top cover, push the release button, slide the CMOD
cover toward the back of the CMOD, and lift it away.
| Caution -
Component damage. CMOD components are extremely sensitive to
electrostatic discharge. Wear a wrist strap and use an anti-static wrist
mat.
|
-
To install the cover, position it over the CMOD chassis with the green
button at the front.
-
Set the cover on the chassis, leaving a gap of approximately one inch (25
mm) between the lead edge of the cover and the front of the CMOD.
-
Ensure that the edges of the cover encapsulate the edges of the chassis,
and that the pins in the cover are aligned with the slots in the chassis
sidewall.
-
Slide the cover toward the front of the CMOD until it locks into
place.
This action is accompanied by a click sound.