| Skip Navigation Links | |
| Exit Print View | |
|
Sun Datacenter InfiniBand Switch 648 Topic Set |
Documentation, Support, and Training
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Checking Logs and Error Messages
Display the Switch Message Log for Power Supplies
Display the Switch Message Log for Fabric Cards
Display the Switch Message Log for Line Cards
Understanding Signal Routing Through the Switch
CXP Connectors and LEDs to Line Card Switch Chip and Port Routes
Line Card Switch Chip to Line Card XBOW Connector Routes
Fabric Card XBOW Connector to Fabric Card Switch Chip Routes
Fabric Card Switch Chip to Fabric Card XBOW Connector Routes
Line Card XBOW Connector to Line Card Switch Chip Routes
Line Card Switch Chip and Port to CXP Connector and LED Routes
Signal Route Through the Switch
Understanding Switch Startup and Component Addition
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Controlling ILOM Targets (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Administering ILOM (Web Interface)
Access ILOM From the Web Interface
Monitoring ILOM Targets (Web Interface)
Controlling ILOM Targets (Web Interface)
Upgrading the Switch Firmware Through ILOM (Web Interface)
Understanding InfiniBand Cabling
Understanding Switch Specifications
Understanding the Installation
Installing the InfiniBand Software Stack
Verifying the InfiniBand Fabric
Understanding Service Procedures
Servicing the Fabric Cards and Fabric Card Fillers
Servicing the InfiniBand Cables
Doing Supportive Software Tasks
Understanding Switch-Specific Commands
The switch message log contains events that happened to the switch hardware. This log is stored on the CMC in the /var/log/syslog file. There are two ways to commands that display the log.
The showlogs command provides a more user friendly means of understanding the system events. The output is succinct and events are system-wide.
The CLIA sel command is used to view the system event log (sel) on a specific IPM controller. The sel command gives greater flexibility to viewing the log and the detail of the log entries than the showlogs command.
Switch Reference, showlogs command
Switch Reference, sel command
|