| Skip Navigation Links | |
| Exit Print View | |
|
Sun Datacenter InfiniBand Switch 648 Topic Set |
Documentation, Support, and Training
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Checking Logs and Error Messages
Display the Switch Message Log for Power Supplies
Display the Switch Message Log for Fabric Cards
Display the Switch Message Log for Line Cards
Understanding Signal Routing Through the Switch
CXP Connectors and LEDs to Line Card Switch Chip and Port Routes
Line Card Switch Chip to Line Card XBOW Connector Routes
Fabric Card XBOW Connector to Fabric Card Switch Chip Routes
Fabric Card Switch Chip to Fabric Card XBOW Connector Routes
Line Card XBOW Connector to Line Card Switch Chip Routes
Signal Route Through the Switch
Understanding Switch Startup and Component Addition
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Controlling ILOM Targets (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Administering ILOM (Web Interface)
Access ILOM From the Web Interface
Monitoring ILOM Targets (Web Interface)
Controlling ILOM Targets (Web Interface)
Upgrading the Switch Firmware Through ILOM (Web Interface)
Understanding InfiniBand Cabling
Understanding Switch Specifications
Understanding the Installation
Installing the InfiniBand Software Stack
Verifying the InfiniBand Fabric
Understanding Service Procedures
Servicing the Fabric Cards and Fabric Card Fillers
Servicing the InfiniBand Cables
Doing Supportive Software Tasks
Understanding Switch-Specific Commands
A reverse-lookup mapping of the I4 switch chip and port to CXP connector and its link LEDs is provided in the following table. The connectors and LEDs are given as connectorletter-location, where:
connector – The identifying number of the connector group (0–11).
letter – The letter identifying the upper (A) or lower (B) connector.
location – The location of the LED, left, center, or right.
|
Note - When using CXP to QSCP splitter cables, the P1, P2, and P3 QSCP connectors are related to the right, center, and left link LEDs respectively.
|