Go to main content
Sun Storage 6 Gb SAS PCIe HBA, Internal Installation Guide For HBA Models SGX-SAS6-INT-Z and SG-SAS6-INT-Z

Exit Print View

Updated: May 2017
 
 

HBA Features

The internal Sun Storage 6 Gb SAS PCIe HBA (SGX-SAS6-INT-Z, SG-SAS6-INT-Z) provides a low-cost, PCI Express SAS solution for computer manufacturers. The HBA uses either a standard or low-profile PCI bracket type and has the following features:

  • Support for over 800 single-pathed, or 400 dual-pathed, internal physical disks that can be accessible by the HBA (for supported configurations, see the storage device documentation)

  • Support for RAID levels 0, 1, and 10

  • Support for a maximum of two logical RAID volumes that can be provided by the HBA

  • Support for a maximum of 10 physical devices within any single RAID volume and a maximum of fourteen physical devices within all RAID volumes combined

  • PCI Express interface that is compatible with the PCI Express Specification, revision 2.0 and backward compatible with the PCI Express Specification, revision 1.1

  • Implementation of the PCI Express interface as an x4 or x8 interface

  • Compatibility with the PCIe Low Profile standards

  • PCI Express transmission and reception data rate that is 5.0 Gb/s in each direction, yielding a total bandwidth of 10 Gb/s for each full-duplex lane

  • Simplified cabling with a point-to-point, serial architecture

  • Smaller and thinner cables that promote unrestricted airflow

  • Serial, point-to-point, enterprise-level storage interface

SAS/SATA Features

The following are the SAS/SATA features supported by the HBA:

  • Serial SCSI protocol (SSP), serial ATA tunneling protocol (STP), and serial management protocol (SMP), as defined in the Serial Attached SCSI (SAS) Specification, version 2.0

  • SAS interface that is compatible with the ANSI Serial Attached SCSI Specification, revision 2.0 and the Serial ATA Specification, revision 2.6

  • Capability of running with either four or eight serial ports for connection to SAS/SATA (Serial ATA) devices

  • Each serial port is capable of 6.0 Gb/s SAS and SATA link rates and 1.5 Gb/s or 3.0 Gb/s SATA link rates


    Note - While each serial port is capable of 6 Gb/s SAS and SATA link rates, only four of the eight serial ports can operate at 6 Gb/s link rates at one time. This is to accommodate platforms that are not designed for 6 Gb/s operation.
  • Support for the easy addition of SAS interfaces to any computer, workstation, or server with a PCI Express bus

  • Four or eight PCIe PHYs, which provide possible host-side maximum transmission and reception rates of up to 4 Gb/s

  • Narrow and wide ports

  • SATA target devices, as defined in the Serial ATA Specification, version 2.6

  • Transfer of data using SCSI information units

Figure 1 shows the physical features of the HBA.

Figure 1  Oracle's Sun Storage 6 Gb SAS PCIe HBA, Internal

image:Image that shows the HBA.