To Apply Power

1. Verify that the Converged Network Adapter is securely installed in the system.
2. Verify that the correct data cable is attached.
3. Refer to your system installation or service manual to determine how to power on the system.
4. Observe the light-emitting diode (LED) status for the power-on self test (POST) results as shown in this section.

   The green LEDs can be seen through openings in the mounting bracket of the adapter, as shown in the following figure.

   
   

   Callout Description 1 Low profile mounting bracket (standard) 2 Port 1 SAN LED 3 Port 1 LC Connector 4 Port 2 LC Connector 5 Port 2 SAN LED 6 Port 1 LAN LED 7 Port 2 LAN LED

   The following table summarizes the LED status conditions.

   Green LED (LAN Traffic) Green LED (SAN Traffic) Activity Off Off Power off Slow flashing (unison) Slow flashing (unison) Power on (no link) On On Link established; no activity Flashing On Link established; transmit and receive LAN only activity On Flashing Link established; transmit and receive SAN only activity Flashing Flashing Link established; transmit and receive LAN and SAN activity Off On or flashing Fatal error detected on LAN function; SAN functioning normally On or flashing Off Inconsistent state detected on Fibre Channel firmware state machine; unable to recover Off Off MPI firmware initialization failed (incorrect checksum, invalid config image, or EDC PHY firmware load failure), or the MPI firmware asserts during runtime and hangs permanently Slow flashing (alternating) Slow flashing (alternating) Beaconing