Removing the Hardware

If you need to remove the adapter, for any reason, follow the instructions in this section. For more detailed removal instructions, see your system installation or service manual.

The following steps summarize the hardware removal process:

1. Halt the operating system and remove power from the system, as required by your system.

2. Remove the adapter hardware.

To Remove the Converged Network Adapter

1. Use an ESD strap (refer to Observing ESD and Handling Precautions).
2. Refer to your system documentation to shut down, power off, and unplug the system, if necessary.
3. Disconnect all cables.
4. Unscrew the case screws and remove the system case.
5. Remove the mounting bracket of the adapter from the system by unscrewing the panel screw or removing the clip, whichever is being used.

   You can now remove the adapter.