To Install the HBA

1. Attach an ESD wrist strap (see Observing ESD and Handling Precautions).
2. Refer to your system installation or service manual to determine an appropriate ExpressModule slot in which to install the HBA.
3. Press down the plastic tab to release the ExpressModule latch and pull the lever out until it is nearly perpendicular with the ExpressModule front panel.

   Figure 2-1  Releasing the HBA Latch

   
   
4. Insert the HBA into its slot, being careful that the tooth on the bottom of the lever does not come in contact with the chassis sheet metal during insertion.
5. When the HBA is inserted nearly all the way into its slot, push the lever back into its fully closed position, allowing the lever tooth to insert the HBA fully into place.