To Test the Installation for the Oracle Solaris OS

1. Use the cfgadm command to verify proper HBA installation.

   # cfgadm
   

   If the HBA is properly installed and connected, you will see output similar to the following.

   Ap_Id		Type			Receptacle				Occupant				Condition
   c3		fc			connected				configured				ok
   c4		fc			connected				configured				ok
   pcie5		ethern/hp			connected				configured				ok
   

2. If the HBA is shown as unconfigured or disconnected, use the cfgadm ‐c configure command to configure the HBA.

   ---

   Note - Diagnostic support for the HBA is included in the SunVTS software. The SunVTS software is available for download at: http://www.sun.com/oem/products/vts

   ---

3. To see the details and state of each FC port, use the fcinfo hba-port command.???
4. To view a list of ports, use the luxadm -e port command.???
5. To plumb and configure GigE ports, use the ifconfig command with the driver name of e1000g.???