Setup and Power-on Recommendations With an Empty System Chassis

1. Before installing server blades, make sure that all of the chassis components are installed (power supplies, fans, NEMs, EMs, etc.).
2. Connect required I/O cables for the chassis (Ethernet, etc.).
3. Install and fully seat Blade 0.
4. Attach all AC power cables from the system chassis power interface module to a power source.

   The chassis automatically applies main power to all blades in the chassis after power is provided to the power supplies. Ensure that all power LEDs are lit.

5. Set up your CMM IP address with a DHCP/Static address.
6. Verify the CMM network and check/setup the blade SP network.
7. Install other blades with a 30 second interval between each blade insertion.

   For example, after Blade 0 has been powered, wait 30 seconds. Then install and fully seat Blade 1 and wait 30 seconds for them to power on.

   Then install and fully install Blade 2 and wait 30 seconds for them to power-on. Repeat the process until all blades are installed.

8. Verify that no fault (amber) LEDs are lit on blade or chassis components (CMM, PSU, blades, etc.).

   If fault LEDs are lit, follow the troubleshooting procedures described in the Sun Blade X6275 M2 Server Module Service Manual and refer to the Product Notes for any known issues.