Go to main content
oracle home
Sun Storage 16 Gb Fibre Channel ExpressModule Host Bus Adapter, Emulex Installation Guide For HBA Model 7101690
Exit Print View
Search Term
Search Scope:
This Document
Entire Library
» ...
Documentation Home
»
Sun Storage 16 Gb Fibre Channel ExpressModule ...
»
Sun Storage 16 Gb Fibre Channel ExpressModule ...
»
HBA Installation, Configuration, and Removal
»
Testing the Installation
»
To Configure the HBA (Oracle Solaris)
Updated: August 2018
Sun Storage 16 Gb Fibre Channel ExpressModule Host Bus Adapter, Emulex Installation Guide For HBA Model 7101690
Document Information
Using This Documentation
Product Documentation Library
Feedback
Chapter 1 HBA Overview
Kit Contents
HBA Features and Specifications
Operating System and Technology Requirements
Boot Support
System Interoperability
Host Platform Support
Storage Support
Array Support
Storage System Support
Tape Storage Support
Unified Storage
Switch Support
Environmental Requirements
Chapter 2 HBA Installation, Configuration, and Removal
Observing ESD and Handling Precautions
Best Practices For HBA Installation
General Best Practices
Best Practices For Switches and Zoning
Best Practices For Booting From SAN (BFS) Configurations
Best Practices For Testing the Environment
Installing the Hardware
To Prepare for HBA Installation
To Install the HBA
Connecting the Copper Cables
To Connect the Copper Cables
Powering on the System
To Apply Power to the System
Viewing LEDs
POST Results
Testing the Installation
To Verify Proper Installation (Oracle Solaris)
To Configure the HBA (Oracle Solaris)
To Verify Attached Storage (Oracle Solaris)
Configuring the HBA for Hot-Plug Operation
To Configure the HBA for Hot-Plug Operation
Removing the Hardware
To Prepare the HBA for Removal Using the Attention (ATTN) Button
To Prepare the HBA for Hot-Plug Removal (Oracle Solaris)
To Remove the HBA Hardware
Chapter 3 Software Installation
Utilities for Upgrading the BIOS and Firmware
To Install Utilities for Updating the BIOS or Firmware:
Upgrading Firmware
To Upgrade Firmware Using the OneCommand Manager GUI
To Upgrade Firmware Using the OneCommand Manager CLI
Installing Diagnostic Software
Diagnostic Support for the Oracle Solaris OS
Diagnostic Support for All Other Supported Operating Systems
To Install Diagnostic Support Utilities for a Supported OS Other Than the Oracle Solaris OS:
Using the OneCommand Manager CLI for Troubleshooting a Fatal Error
About Automatic Firmware Dumps
Installing Drivers
Installing Drivers for the Oracle Solaris OS
Installing Drivers for All Other Supported Operating Systems
Chapter 4 Known Issues
System Hangs When Performing a Hot Plug Operation
Link Aggregation Control Protocol (LACP) Cannot Be Used In Certain Conditions
SAN Boot Fails Via Direct Attached Storage on Oracle SPARC Systems
Language:
English
To Configure the HBA (Oracle Solaris)
If the HBA is shown as unconfigured or disconnected, use the
cfgadm ‐c configure
command to configure the HBA.
Previous
Next