Go to main content

Managing SAN Devices and I/O Multipathing in Oracle^® Solaris 11.4

Exit Print View

» ...Documentation Home » Oracle Solaris 11.4 Information Library » Managing SAN Devices and I/O Multipathing in ... » Configuring Oracle Solaris I/O Multipathing ... » Configuring Multipathing on a Port Basis

Updated: November 2020

Managing SAN Devices and I/O Multipathing in Oracle^® Solaris 11.4

Document Information

Using This Documentation

Chapter 1 About Oracle Solaris Storage Stack

Chapter 2 About Oracle Solaris I/O Multipathing

Chapter 3 Configuring Oracle Solaris I/O Multipathing Features

Displaying Multipathing Information

Failover of a Logical Unit

Disabling and Enabling a Logical Unit Path

Configuring Third-Party Storage Devices

Configuring Multipathing on Tape Drives

Configuring Multipathing on a Port Basis

Disabling and Enabling Oracle Solaris I/O Multipathing

Configuring Automatic Failback

Configuring Load Balancing Policy for Oracle Solaris I/O Multipathing

Chapter 4 Configuring Fibre Channel Devices

Chapter 5 Configuring an Oracle Solaris iSCSI Initiator

Chapter 6 Configuring SAS Devices

Chapter 7 Persistent Binding for Tape Devices

Appendix A Manual Configuration for Fibre Channel Devices

Appendix B Troubleshooting Multipathing Problems

Appendix C Tuning Disk Target Driver Properties

Appendix D Supported HBAs in FC or FCoE Mode

Language:

Configuring Multipathing on a Port Basis

You can disable or enable multipathing on a specific FC host bus adapter (HBA) controller ports.

Copyright © 2009, 2020, Oracle and/or its affiliates.