Change a SEFOS User Privilege Level
Configure Network Management From the Web Interface
Configure Network Management From the CLI
Log Out of the Oracle ILOM CLI
Configuring the SEFOS Environment
Enable or Disable the Timeout for Line Connections
Configure the Default IP Address
Configure the IP Address for an Interface
Configure the Name of the Configuration File
Enable or Disable Trap Generation on an Interface
Save the Configuration to a File
Copy a Configuration File to a Remote Location
Copy a Configuration File From a Remote Location to Flash
Copy a Configuration File From One Remote Location or Flash to Another Remote Location or Flash
Copy a System Log to a Remote Location
Configuring the Switching Feature
Configuring the Routing Feature
Configure Static Unicast Route Entries
See Switching Feature Topology.
Port 1 – Connected to host server A (IP address 20.0.0.10)
Port 2 – Connected to host server B (IP address 20.0.0.20)
Ports 21-22 – Connected to ports 21-22 on the SEFOS-2 switch
See Connect to SEFOS.
SEFOS-1# configure terminal SEFOS-1(config)# vlan 101 SEFOS-1(config-vlan)# ports extreme-ethernet 0/1-2 untagged extreme-ethernet 0/1-2 SEFOS-1(config-vlan)# vlan active SEFOS-1(config-vlan)# exit
SEFOS-1# configure terminal SEFOS-1(config)# interface range extreme-ethernet 0/1-2 SEFOS-1(config-if-range)# switchport pvid 101 SEFOS-1(config-if-range)# no shutdown SEFOS-1(config-if-range)# exit
SEFOS-1# configure terminal SEFOS-1(config-int)# interface vlan 101 SEFOS-1(config-int)# ip address 20.0.0.1 255.0.0.0 SEFOS-1(config-int)# no shutdown SEFOS-1(config-int)# exit
SEFOS-1# show ip interface vlan1 is down, line protocol is down Internet Address is 10.0.0.1/8 Broadcast Address 10.255.255.255 vlan101 is up, line protocol is up Internet Address is 20.0.0.1/8 Broadcast Address 10.255.255.255
SEFOS-1# show interface status Port Status Duplex Speed Negotiation ---- ------ ------ ----- ----------- Ex0/1 connected Full 10 Gbps Auto-Negotiation Ex0/2 connected Full 10 Gbps Auto-Negotiation ... Ex0/4 not connected Full 10 Gbps Auto-Negotiation SEFOS-1# show interface description Interface Status Protocol --------- ------ -------- Ex0/1 up up Ex0/2 up up Ex0/3 down down Ex0/4 down down ... vlan101 up up
The ping should be successful.
SEFOS-1# show mac-address-table Vlan Mac Address Type Ports ---- ----------- ---- ----- 101 00:14:4f:6c:7d:e9 Learnt Ex0/1 Total Mac Addresses displayed: 1
Note - The MAC address displayed must correspond to the MAC address of host A.
To configure the topology, all of the interfaces should be up. If they are not up, use the no shutdown command to bring up the ports.
SEFOS-1# configure terminal SEFOS-1(config)# interface range ex 0/21-22 SEFOS-1(config-if-range)# switchport pvid 101 SEFOS-1(config-if-range)# no shutdown SEFOS-1(config-if-range)# end
In both switches, ensure that the following interfaces are up: 0/1, 0/2, 0/21, 0/22.