Change a SEFOS User Privilege Level
Configure Network Management From the Web Interface
Configure Network Management From the CLI
Log Out of the Oracle ILOM CLI
Configuring the SEFOS Environment
Enable or Disable the Timeout for Line Connections
Configure the Default IP Address
Configure the IP Address for an Interface
Configure the Name of the Configuration File
Enable or Disable the Incremental Save Flag
Enable or Disable the Auto Save Flag
Save the Configuration to a File
Copy a Configuration File to a Remote Location
Copy a Configuration File From a Remote Location to Flash
Copy a Configuration File From One Remote Location or Flash to Another Remote Location or Flash
Copy a System Log to a Remote Location
Configuring the Switching Feature
Configuring the Routing Feature
Configure Static Unicast Route Entries
This task describes how to enable or disable trap generation either on the physical interface or on the port-channel interface.
Note - Refer to the Oracle ILOM 3.0 Daily Management – CLI Procedures Guide for information to configure the SNMP manager for trap generation.
See Connect to SEFOS.
SEFOS-1# configure terminal
SEFOS-1(config)# interface extreme-ethernet 0/1
SEFOS-1(config-if)# snmp trap link-status
SEFOS-1(config-if)# no snmp trap link-status
SEFOS-1(config-if)# end
SEFOS-1# show interface extreme-ethernet 0/1 ... Link Up/Down Trap is enabled ...
or,
SEFOS-1# show interface extreme-ethernet 0/1 ... Link Up/Down Trap is disabled ...
If the trap is enabled, the switch sends trap messages to the SNMP manager on specific events such as link up, link down, and so on.