Install the CMA
The cable management assembly is an optional
assembly that you can use to route the server cables in the rack.
- Unpack
the CMA parts.
- Take the CMA to the back of the
equipment rack and ensure that you have adequate room to work around
the back of the server.
Note - References to left or right in this procedure assume
that you are facing the back of the equipment rack.
- Remove tape to separate the parts
of the CMA.
- Insert the CMA mounting bracket
connector into the right slide rail until the connector locks into
place with an audible click.
|
|
1 |
CMA mounting bracket |
2 |
Right slide rail |
|
- Insert the right CMA slide rail
connector into the right slide rail assembly until the connector
locks into place with an audible click.
|
|
1 |
CMA slide rail connector |
2 |
Right slide rail |
|
- Insert the left CMA slide rail
connector into the left slide rail assembly until the connector
locks into place with an audible click.
|
|
1 |
CMA slide rail connector |
2 |
Left slide rail |
|
- Install and route cables to your
server, as required.
- If required, attach the cable
hooks and loop straps to the CMA, and press the hooks and straps
into place to secure the cables.
Note - Cable hooks and loop straps are preinstalled on the
CMA. Perform the procedure in this step if you need to reinstall
cable hooks and straps on the CMA.
For best results, place three cable straps, evenly spaced,
on the rear-facing side of the CMA, and three cable straps on the
side of the CMA nearest the server.
|
|
1 |
CMA cable strap |
2 |
CMA arm |
|