Topology Example

Language:

Before enabling PIMv6 in a router, you must configure the router and the host with the IP address and VLAN connectivity. The following example topology is referenced in the configuration steps in this guide.

image:Figure showing the example topology configuration of a router and host

This topology consists of two routers (router A and router B) with two physical interfaces (P1 and P2), which are extreme-ethernet 0/1 and extreme-ethernet 0/2 respectively.

The following table shows the configuration values of the IPv4 and IPv6 addresses for each interface.

Switch or Host	Interface	IPv4 Address	IPv6 Address and Prefix Length
Router A	Port 3 (`VLAN 7`)		`7777::11/112`
	Port 15 (`VLAN 2`)		`2222::12/112`
	Port 4 (`VLAN 1`)	`12.0.0.1/24`	`1111::14/112`
Router B	Port 3 (`VLAN 7`)		`7777::21/112`
	Port 15 (`VLAN 3`)		`3333::22/112`
	Port 4 (`VLAN 1`)	`12.0.0.2/24`	`1111::24/112`
Host B	Port 3 (`VLAN 3`)		`3333::53/112`
Host A	Port 5 (`VLAN 2`)		`2222::63/112`