Configuring the PIMv6 group threshold sets the maximum limit for the rate of the flow of data in the group. Configuring the source threshold sets the maximum limit for the rate of the flow of data from the source to the receiver. When the rate of the flow of data exceeds the SPT group or source threshold, switching to the SPT is initiated. You must configure the threshold value to switch to SPT.
SEFOS# configure terminal SEFOS(config)# set ipv6 pim enable SEFOS(config)# end
SEFOS# configure terminal SEFOS(config)# set ip pim threshold spt-grp 10
SEFOS(config)# set ip pim threshold spt-src 15 SEFOS(config)# end
SEFOS# show ipv6 pim thresholds PIM SPT Threshold Information ----------------------------- Group Threshold : 10 Source Threshold : 15 Switching Period : 0 PIM SPT-RP Threshold Information -------------------------------- Register Threshold : 0 RP Switching Period : 0 Register Stop rate limit : 5