Go to main content
Oracle® Fabric OS 1.0.2 Administration Guide

Exit Print View

Updated: November 2016
 
 

Configuring LAGs

LAGs are supported on the fabric, but the LAG must also be configured on the peer Ethernet device. For syntax information, refer to lag in Oracle Fabric OS 1.0.2 Command Reference.

Setting options on the LAG might also require you to set the corresponding value for the peer Ethernet device's LAG configuration.

To set LAG options, vNICs cannot be assigned to the port. As a result, if a port is unassigned to a LAG and you want to assign it to a LAG, perform the following actions:

  1. Delete any vNICs supported by the port.

  2. Add the port to the LAG.

  3. Add the vNICs to the port.


Note -  After setting the LAG options, run the show lag command to verify the configuration changes.

There is no dependency for when to configure the peer or the fabric, so these commands can be issued on the peer before or after LAG is configured on the fabric. Refer to Configuring LAGs in Oracle Fabric OS 1.0.2 Command Reference for an example of LAG configuration for a peer device.

Related Information