vHBA Commands
Assuming the Fibre Channel module and ports are in an up/up state, you can
configure vHBAs. This table documents the commands for configuring, managing, and
displaying vHBAs. For procedures on configuring, managing, and displaying vHBAs,
refer to the documentation.
|
|
|
|
Configure and manage vHBAs
|
add vhba name
slot/port
set vhba name
clear
set vhba name
full-scan
set vhba name
prescan
set vhba name
remove-prescan
set vhba name
rescan
set vhba name
down
set vhba name
up
set vhba name
-descr=
set vhba name
fabric-link-down-timeout
set vhba name
-if=
remove vhba
name|*
|
|
|
Display vHBA information
|
show vhbas
name
show vhba name
stats
show vhba name
alarms
show vhba name
errors
show vhba name
map
show vhba name
warnings
show vhba name
where
show vhba name
target
show vhba name
targets
show vhba name
througput
show vhba name
-detail
|
|
Check for vHBA errors
|
show vhba name
alarms
show vhba name
errors
show vhba name
warnings
|
If alarms are present, resolve them. Refer to the
Oracle® Fabric Interconnect F2-12 Service
Manual.
|
|