Remove the Filler Panel
Use this procedure to remove a filler panel or existing module from the slot where you are installing the module.
Note - To maintain thermal stability, never operate the switch with an empty slot. Remove filler panels only as you replace them with an I/O module in a one-for-one basis.
- Identify the prerequisite and subsequent installation tasks that you must perform in conjunction with this task.
-
At the location where you are installing the module, remove the filler panel,
if installed.
-
Squeeze the top and bottom of the release lever, and pull the lever in
a downward motion.
The filler panel is unseated from the slot connection.
-
Use the release lever to pull the filler panel from the switch
chassis.
- Use your free hand to take the weight of the filler panel, as it comes free of the chassis.
- Set the filler panel aside and save it for future use.
-
Squeeze the top and bottom of the release lever, and pull the lever in
a downward motion.
-
Install the module.
See Install the Module.