6.1 Replacing the Server Top Cover
When you have completed a service procedure, replace the server top cover, using
the following procedure.
Replace the Server Top Cover
Refer to Installing the Top Cover when completing the following procedure.
- Place the top cover on the chassis.
Set the cover down so that it is slightly forward of the
rear of the server by about 1 inch (25.4 mm).
- Slide the top cover toward the rear of the chassis until the rear
cover lip engages with the rear of the chassis.
- To close the top cover, press down on the cover with both hands
until both latches engage.
Figure 6-1 Installing the Top Cover