To Verify Attached Storage (Oracle SPARC)

• If online storage is connected to the HBA, use the apply show-children command to list the attached storage.

  ---

  Note - You might need to run the reset-all command before using the apply show-children command.

  ---

  In the example that follows, a storage JBOD has one target and two LUNs attached to one port of a dual port HBA.

  {0} ok show-disks
  a) /pci@0/pci@0/pci@8/pci@0/pci@2/SUNW,qlc@0,1/fp@0,0/disk
  b) /pci@0/pci@0/pci@8/pci@0/pci@2/SUNW,qlc@0/fp@0,0/disk
  c) /pci@0/pci@0/pci@2/scsi@0/disk
  d) /pci@0/pci@0/pci@1/pci@0/pci@1/pci@0/usb@0,2/storage@2/disk
  q) NO SELECTION
  Enter Selection, q to quit: b
  {0} ok select /pci@0/pci@0/pci@8/pci@0/pci@2/SUNW,qlc@0
  QLogic QLE2562  Host Adapter FCode(SPARC): 2.03  06/30/08
  Firmware version 4.03.02
  {0} ok show-children
  Adapter portID - 11000
  ************** Fabric Attached Devices **************
    Dev# 0(0)   PortID 100e8    Port WWN 21000011c68115b3
     LUN    0(0)    DISK  SEAGATE ST336854FC      0005
   
    Dev# 1(1)   PortID 10100    Port WWN 201500a0b84718a4
     LUN    a(10)    DISK  STK     FLEXLINE 380    0619
     LUN    b(11)    DISK  STK     FLEXLINE 380    0619
   
  {0} ok