Confirming Switch Specifications
Preparing to Install the Switch
Install the Switch in the Rack
Finish the Switch Installation
Connecting to the Service Processor
Oracle ILOM Features Not Supported
Verify the DHCP-Assigned IP Address and Host Name
Configure Network Management From CLI (SER MGT)
Log Into Oracle ILOM Web (NET MGT)
Log Into Oracle ILOM CLI (NET MGT)
Log Into Oracle ILOM CLI (SER MGT)
SER MGT Port Configuration Parameters
Configure Network Management From Web
Configure Network Management From CLI (NET MGT)
Configuring SEFOS User Privileges
Change a SEFOS User Privilege Level
Check Switch Status (Oracle ILOM)
Caution - Fiber optic Ethernet cables with laser transceivers must be Class I. |
Caution - Do not allow any copper core Ethernet cable to bend tighter than a 5 inch (127 mm) radius. Do not allow any optical Ethernet cable to bend tighter than a 3.4 inch (85 mm) radius. Tight bends can damage the cable internally. |
Caution - Do not use zip ties to bundle or support Ethernet cables. The sharp edges of the ties can damage the cables internally. |
Caution - Do not allow any Ethernet cable to experience extreme tension. Do not pull on an Ethernet cable or allow it to drag. Unroll an Ethernet cable for its length. Pulling on an Ethernet cable can damage the cables internally. |
Caution - Do not twist an Ethernet cable more than 1 revolution for its entire length. Twisting an Ethernet cable can damage the cable internally. |
Caution - Do not route Ethernet cables where they might be stepped upon or experience rolling loads. Such a crushing effect can damage the cable internally. |