Confirming Switch Specifications
Preparing to Install the Switch
Install the Switch in the Rack
Finish the Switch Installation
Connecting to the Service Processor
Oracle ILOM Features Not Supported
Verify the DHCP-Assigned IP Address and Host Name
Configure Network Management From CLI (SER MGT)
Log Into Oracle ILOM Web (NET MGT)
Log Into Oracle ILOM CLI (NET MGT)
Log Into Oracle ILOM CLI (SER MGT)
SER MGT Port Configuration Parameters
Configure Network Management From Web
Configure Network Management From CLI (NET MGT)
Configuring SEFOS User Privileges
Change a SEFOS User Privilege Level
Check Switch Status (Oracle ILOM)
Two RJ-45 network management ports are located on the front left of the switch. See Front Panel Components.
Use NET MGT 0 (Port A) to provide Ethernet CLI and web interface connections to a system console for administering the switch remotely.
The NET MGT connector is a 100 BASE-T Ethernet interface. This connector is preferred because it permits remote management of the switch over the Ethernet network.
Note - Do not use NET MGT 1 (Port B). Port B is functional but currently has some limitations and is not supported at this time.
This figure and table describe the pinouts of the NET MGT connector.
|