Confirming Switch Specifications
Preparing to Install the Switch
Install the Switch in the Rack
Finish the Switch Installation
Connecting to the Service Processor
Oracle ILOM Features Not Supported
Verify the DHCP-Assigned IP Address and Host Name
Configure Network Management From CLI (SER MGT)
Log Into Oracle ILOM Web (NET MGT)
Log Into Oracle ILOM CLI (NET MGT)
Log Into Oracle ILOM CLI (SER MGT)
SER MGT Port Configuration Parameters
Configure Network Management From Web
Configure Network Management From CLI (NET MGT)
Configuring SEFOS User Privileges
Change a SEFOS User Privilege Level
Check Switch Status (Oracle ILOM)
Management of the switch is done at the management console, which is a 10/100 Ethernet connection at the NET MGT connectors. See Front Panel Components.
NET MGT 0 (Port A)
NET MGT 1 (Port B)
Typically, the NET MGT connection is the default means of communicating with the management controller. The controller has a DHCP client in operation and requires the Ethernet network to have a DHCP server. The DHCP server must be configured with the MAC address of the management controller, so that the server can provide an IP address to the management controller upon boot.
Note - Do not use NET MGT 1 (Port B). Port B is functional but currently has some limitations and is not supported at this time.
The serial device used to connect to the SER MGT connector can be a serial terminal, a terminal server, or a serial connection running on a system or laptop. Because of the nature of the serial signal, a SER MGT cable cannot be reliably used if it is more than 10 meters long.