JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Storage 6 Gb SAS REM HBA

Installation Guide For HBA Models SGX-SAS6-REM-Z and SG-SAS6-REM-Z

Oracle Technology Network
Library
PDF
Print View
Feedback
search filter icon
search icon

Document Information

Using This Documentation

Chapter 1 HBA Overview

Chapter 2 Hardware Installation and Removal

Observing ESD and Handling Precautions

Installing the HBA

To Prepare for Hardware Installation

To Install the HBA

To Connect the HBA to Drives

To Complete the Installation

Validating the Solaris Labels of the HBA Logical Drives (Solaris OS)

To Verify That the Solaris Label of a Logical Drive Is Valid

Next Steps

Removing the HBA

To Remove the HBA

Chapter 3 Creating a Bootable Drive in a Preboot Environment

Chapter 4 HBA Software Installation

Chapter 5 Activating Volumes

Chapter 6 Known Issues

Appendix A HBA Specifications

Glossary

To Install the HBA

  1. Refer to the service or installation manual for your particular system for instructions about how to locate the REM connector in the chassis of the system.
  2. Attach an antistatic wrist strap and remove the HBA from its packaging.

    See Observing ESD and Handling Precautions.

  3. Insert the notch of the HBA into the bracket in the system (located near the mezzanine plug connector), and then connect the 210-pin mezzanine plug connector on the HBA to the 210-pin mezzanine plug connector on the system board (see Installing Oracle's Sun Storage 6 Gb SAS REM HBA).

    Figure 2-1  Installing Oracle's Sun Storage 6 Gb SAS REM HBA

    image:Figure that depicts the installation of the Sun Storage 6 Gb SAS REM HBA

    Figure Legend

    1 Insert the notch of the HBA onto the bracket.

    2Press down here.


    Note - The configuration of the enclosure might not be the same as shown in this illustration.
  4. Press down gently and firmly to seat the HBA in the mezzanine plug connector.