For setup, testing, or service purposes, you can connect cables directly to the server module SP by first attaching a dongle cable to the UCP on the front panel of the server module.
Caution - Dongle cables should be removed when not in use. These cables have not been evaluated for electromagnetic compatibility compliance and are not to be used during normal system operation. |
There are two types of dongle cables you can use:
UCP-3 – Three-connector dongle cable (preferred) ships with the server module. Use the RJ-45 connector to connect to the server module SP.
UCP-4 – Four-connector dongle cable (previous version). You must use the DB-9 connector to connect to the server module SP. The RJ-45 connector is not supported. If you need an RJ-45 connection, attach an optional DB-9-to-RJ-45 adapter to the DB-9 connector.
Figure 1 UCP-3 Three-Connector Dongle Cable
1 Dongle connector attaching to the server module UCP
2RJ-45 serial connector
3USB 2.0 (two connectors)
4VGA 15-pin female connector
5Insertion and release buttons
Figure 2 UCP-4 Four-Connector Dongle Cable
1 Dongle connector attaching to the server module UCP
2RJ-45 serial connector (Do not use this connector on the UCP-4)
3DB-9 serial male connector (TTYA)
4USB 2.0 (two connectors)
5VGA 15-pin female connector
6Insertion and release buttons