How to Modify a Protection Group

Language:

Perform this procedure to modify the properties of a protection group.

Note - You can also accomplish this procedure by using the Oracle Solaris Cluster Manager GUI. Click Partnerships, click the partnership name to go to its page, then in the Protection Groups section click the protection group name. In the Protection Group page, click the Properties tab, then click Edit. For more information about Oracle Solaris Cluster Manager, see Chapter 13, Using the Oracle Solaris Cluster GUI, in Oracle Solaris Cluster System Administration Guide .

Before You Begin

Ensure that the protection group you want to modify exists locally.

Log in to one of the cluster nodes.
You must be assigned the Geo Management RBAC rights profile to complete this procedure. For more information about RBAC, see Securing Geographic Edition Software in Oracle Solaris Cluster Geographic Edition Installation and Configuration Guide .
Modify the configuration of the protection group.
This command modifies the properties of a protection group on all nodes of the local cluster. If the partner cluster contains a protection group of the same name, this command also propagates the new configuration information to the partner cluster.
```
# geopg set-prop -p property-setting [-p...] protection-group
```
–p property-setting

Specifies the properties of the protection group.

For more information about the protection group properties you can set, see Appendix A, Standard Geographic Edition Properties.

protection-group

Specifies the name of the protection group.

For information about the names and values that are supported by Geographic Edition software, see Appendix B, Legal Names and Values of Geographic Edition Entities.

For more information about the geopg command, see the geopg (1M) man page.