Rear Cable Connections
and Ports
The following figure shows the locations of cable connectors
and ports on the back of the Oracle Exadata Storage Server X6-2 High Capacity and the cables and devices
that you would typically connect to them.
|
|
|
1 |
Power supply 0 input power |
The storage server has two power supply connectors,
one for each power supply.
Do not attach power cables to the power supplies until you have finished connecting the data
cables to the storage server. The storage server goes into standby power mode, and the
Oracle ILOM service processor initializes when the AC power cables are
connected to the power source. System messages might be lost after 60
seconds if the storage server is not connected to a terminal, PC, or
workstation.
Note - Oracle ILOM will signal a fault on any installed power supply
that is not connected to an AC power source, since it might indicate
a loss of redundancy. |
2
|
Power supply 1 input power
|
|
3
|
Ethernet ports (NET 3, NET 2, NET 1, NET 0)
|
The four 10-Gigabit Ethernet ports enable you to connect the system to
the network. See Ethernet Ports for more information.
|
4
|
USB ports (USB 0, USB 1)
|
The two USB ports support hot-plugging. You can connect and disconnect
USB cables and peripheral devices while the storage server is running without
affecting system operations.
|
5 |
Network management port (NET MGT) |
The service processor NET MGT port is the optional connection to the Oracle ILOM service
processor. The NET MGT port is configured by default to use Dynamic Host Configuration Protocol
(DHCP). The service processor NET MGT port uses an RJ-45 cable for a 10/100/1000BASE-T
connection. |
6
|
Serial management port (SER MGT)
|
The service processor SER MGT port uses an RJ-45 cable and is the default connection to the
Oracle ILOM service processor. This port supports local connections to the
storage server and only recognizes Oracle ILOM command-line interface (CLI)
commands. Typically, you connect a terminal or terminal emulator to this
port.
Note -
This port does not support network connections.
|
|