Connect the SER MGT Cable

1. Identify the prerequisite and subsequent installation tasks that you must perform in conjunction with this task.

   See Installation Task Overview.

2. Orient the RJ-45 connector to the SER MGT receptacle.

   The tab is down for the receptacle.

   
   
3. Insert the connector into the receptacle until it clicks, securing it in place.
4. Connect the other end of the SER MGT cable to a serial device.

   See Connect a Serial Management Device to the SER MGT Port.

Related Information

• Connect a Serial Management Device to the SER MGT Port

• Connect Power Cords

• Power On the Switch

• Log In to the SP (SER MGT)

• Assign a Static IP Address to the SP

• Assign a Static IP Address to the SCP

• Log In to the SP (Network Management)