ZS3-4 Standalone to Mixed Disk Shelves (2 HBAs)
The following figures show a subset of the supported configurations for Oracle ZFS Storage ZS3-4 standalone controllers with two HBAs. To cable the controller to the disk shelves, see Getting Started with Cabling.
Using mixed disk shelves on a controller requires the following:
-
The controller must use only 4X4 port SAS-2 HBAs
-
Do not use mixed disk shelves in the same chain
Note - For port locations, see the hardware overview section for the corresponding controller in Oracle ZFS Storage Appliance Installation Guide. 4X4 port SAS-2 HBAs are only supported with release AK 2013.1.0 and later.
Figure 465 Standalone ZS3-4 controllers with two HBAs connected to two mixed disk shelves in two chains (DE2-24 shown on the left)
Figure 466 Standalone ZS3-4 controllers with two HBAs connected to three mixed disk shelves in three chains (DE2-24 shown on the left)
Figure 467 Standalone ZS3-4 controllers with two HBAs connected to four mixed disk shelves in four chains (DE2-24 shown on the left)
Figure 468 Standalone ZS3-4 controllers with two HBAs connected to multiple mixed disk shelves in four chains (DE2-24 shown on the left)
Figure 469 Multiple DE2-24 disk shelves in a single chain
Figure 470 Multiple Sun Disk Shelves in a single chain
