ZS3-2 Clustered to Mixed Disk Shelves (1 HBA)
The following figures show a subset of the supported configurations for Oracle ZFS Storage ZS3-2 clustered controllers with one HBA. To cable the controller to the disk shelves, see Getting Started with Cabling.
Using mixed disk shelves on a controller requires the following:
-
The controller must use only 4X4 port SAS-2 HBAs
-
Do not use mixed disk shelves in the same chain
Note - For port locations, see the hardware overview section for the corresponding controller in Oracle ZFS Storage Appliance Installation Guide. 4X4 port SAS-2 HBAs are only supported with release AK 2013.1.0 and later.
Figure 523 Clustered ZS3-2 controllers with one HBA connected to two mixed disk shelves in two chains (DE2-24 shown on the left)
Figure 524 Clustered ZS3-2 controllers with one HBA connected to multiple mixed disk shelves in two chains (DE2-24 shown on the left)
Figure 525 Multiple DE2-24 disk shelves in a single chain
Figure 526 Multiple Sun Disk Shelves in a single chain
