ZS3-2 Standalone to Mixed Disk Shelves (1 HBA)
The following figures show a subset of the supported configurations for Oracle ZFS Storage ZS3-2 standalone controllers with one HBA. To cable the controller to the disk shelves, see Getting Started with Cabling.
Using mixed disk shelves on a controller requires the following:
-
The controller must use only 4X4 port SAS-2 HBAs
-
Do not use mixed disk shelves in the same chain
Note - For port locations, see the hardware overview section for the corresponding controller in Oracle ZFS Storage Appliance Installation Guide. 4X4 port SAS-2 HBAs are only supported with release AK 2013.1.0 and later.
Figure 542 Standalone ZS3-2 controller with one HBA connected to two mixed disk shelves in two chains (DE2-24 shown on the left)
Figure 543 Standalone ZS3-2 controller with one HBA connected to multiple mixed disk shelves in two chains (DE2-24 shown on the left)
Figure 544 Multiple DE2-24 disk shelves in a single chain
Figure 545 Multiple Sun Disk Shelves in a single chain
