Reinstall the Server Into the Rack
After servicing the system, reinstall it into the rack.
 | Caution - Deploy any rack anti-tilt mechanisms before installing the server into the rack. |
| Caution - The server weighs approximately 35.0 lbs (15.88 kg). Two people are required to carry the chassis and install it into the rack. |
-
Lift the server from the antistatic mat, and reinstall the server into the
rack.
Refer to Installing the Server Into a Rack in Oracle Servers X7-2 and X7-2L Installation Guide for the installation instructions specific to your rackmount kit.
-
If the cable management arm (CMA) is not installed, that is, you removed it
because you removed the server completely out of the rack, install the
CMA.
For installation instructions for the CMA, refer to Install the Cable Management Arm (Optional) in Oracle Servers X7-2 and X7-2L Installation Guide.
-
If the cables are disconnected from the back of the server, that is, you
disconnected the cables because you removed the server completely out of the
rack, reconnect the cables.
- For instructions to reconnect cables to the back of the server, see Reconnect Data Cables and Power Cords.
- To identify the location of cable connectors on the back of the server, refer to Back Panel Connector Locations.