Install an NVMe Storage Drive
Perform this procedure to physically install an NVMe storage drive into the
server.
After you physically remove an NVMe drive from the server, wait at least 10
seconds before installing a replacement drive.
-
Remove the replacement drive from its packaging and place the drive on an
antistatic mat.
-
If necessary, remove the drive filler panel.
-
Align the replacement drive with the drive slot.
The drive is physically addressed according to the slot in which it is
installed. It is important to install a replacement drive in the same slot
as the drive that was removed.
-
Slide the drive into the slot until the drive is fully seated.
See Install a Storage Drive.
-
Close the drive latch to lock the drive in place [2].
See Install a Storage Drive.